Using The Device; Unpacking; Check Package Contents; Fitting The Car Cradle - Tronic TKHQ 10 A1 Mode D'emploi

Using the device

Unpacking

Remove all parts and the operating instructions from the packaging.
♦
Remove all packaging material.
♦

Check package contents

The following components are included in delivery:
Car holder with clamping device for air vents 2 (two parts)
▯
Car/USB adapter 0
▯
Charging cable q
▯
These operating instructions w
▯
NOTE
Check the package for completeness and signs of visible damage.
►
If the delivery is incomplete or damage has occurred as a result of
►
defective packaging or during transport, contact the service hotline
(see section Service).

Fitting the car cradle

Unscrew the screw ring r from the car cradle.
♦
Place the screw ring r over the ball joint t and press the ball joint t
♦
into the ball joint socket e (see fig. B).
Screw the screw ring r clockwise firmly onto the ball joint socket e.
♦
TKHQ 10 A1
GB │ IE │
11 ■