Dometic Waeco MagicComfort MSH 300 Instructions De Montage Et De Service page 25

MagicComfort MSH300, MSH301
To make and test the electrical connection, the following tools are required:
 Diode test lamp (8) or voltmeter (9)
 Crimping tool (10)
 Insulating tape (11)
 Hot air blower (13)
 Soldering iron (14)
 Solder (15)
 Cable bushing sleeves (if necessary)
To fasten the cables you may require additional cable binders.
6.2 Installing the seat heater
Removing the seat
➤ Secure the vehicle against rolling away.
A
NOTICE!
For vehicles with side air bags in the seat backrest, observe the
manufacturer's instructions on removing the seats and the
upholstery.
➤ Check the suitability for installation using these installation instructions
and the manufacturer's information.
➤ Remove the fastening screws from the vehicle seat.
➤ Lift the seat out of the vehicle.
Preparing the seat
➤ Remove all plastic panelling from the seat to ensure the fastening of the
cover fabric can be reached.
➤ Separate the backrest from the seat (fig. 7, page 4 and fig. 8, page 4).
➤ Open the seat cover on the seat surface.
The cover fabric is usually tucked into a seam on the frame with a wide
cardboard strip or metal wire.
➤ Remove the fasteners using a screwdriver and pliers (fig. 9, page 4 and
fig. 0, page 4).
EN
Installing the seat heater
25