Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.8 - Memorising a SECOND (third, fourth, etc.) transmitter
To perform these procedures you must have a transmitter ("old") already memorised.
5.8.1 - Memorising a second transmitter "Mode I"
Warning! – This procedure memorises the new transmitter in "Mode I", regardless of the Mode in which the old to transmitter was memorised.
01. (on the new transmitter) keep the n key pressed for 8 seconds and then release it (in this case the motor does not perform any movement).
02. (on the old transmitter) Press any key which has already been memorised three times (the motor will start performing the manoeuvre associated with that key).
03. (on the new transmitter) Give 1 pulse to the n key. After a while the motor performs 3 movements to confirm the memorisation. Warning! If the motor performs 6
movements, it means that its memory is full.
01
8
sec.
New
Note – When performing the procedure, you can cancel it at any time by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
5.8.2 - Memorising a second transmitter in "Mode II"
Warning! – This procedure memorises the new transmitter in "Mode II", regardless of the Mode in which the old to transmitter was memorised.
01. (on the new transmitter) Hold the key to be memorised down for 8 seconds (for example: the n key), then release it (in this case the motor does not perform any
movement).
02. (on the old transmitter) Keep the n key pressed and wait for the motor to perform 4 movements. Upon completion, release the key.
03. (on the old transmitter) Briefly press the n key a certain number of times depending on the and you want to memorise:
1 pulse = Up command
2 pulses = Up command after 10 seconds
3 pulses = Up command after 20 seconds
4 pulses = Down command
5 pulses = Down command after 10 seconds
6 pulses = Down command after 20 seconds
7 pulses = Stop command
8 pulses = Step-by-step command
After about 10 seconds, the motor performs a number of movements equal to the number impulses given with the transmitter.
04. (on the new transmitter) Press the same key as you pressed in point 01 and hold it down while the motor performs 3 movements. Upon completion, release the
key. Warning! If the motor performs 6 movements, it means that its memory is full.
example
01
8
sec.
New
03
Old
same
04
01
New
Note – When performing the procedure, you can cancel it at any time by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
Programs and accessory adjustments
example
02
Old
02
Old
x 1 = Up
x 1 = Salita
x 2 = Up after 10 seconds
x 2 = Salita dopo 10 secondi
x 3 = Up after 20 seconds
x 3 = Salita dopo 20 secondi
x 4 = Down
x 4 = Discesa
x 5 = Down after 10 seconds
x 5 = Discesa dopo 10 secondi
x 6 = Down after 20 seconds
0,5
x 6 = Discesa dopo 20 secondi
x 7 = Stop
sec.
x 7 = Stop
x 8 = Step-by-step
5
sec.
3
03
X 3
0,5
sec.
New
5
sec.
4
10
sec.
?
THE
END
END
THE
END
0,5
END
sec.
3
1 /
2 /
3 /
4 /
English – 6
Publicité
Table des Matières
