Operating - SilverCrest SKHD 1800 A1 Mode D'emploi

RP90873 Keramikheizlüfter LB1 Seite 52 Donnerstag, 27. Juni 2013 5:48 17
7.1 Using the appliance for the first time
Insert the mains plug into a wall socket that
complies with the technical data (see
"3. Technical data" on page 47).
7.2 Selecting functions
To select the available functions, turn the
function selector 1 to the relevant symbol.
II High heat setting
I Low heat setting
Fan without heater
Appliance is switched off
As soon as the appliance is working the
indicator light 5 comes on.
7.3 Selecting the temperature
Set with the temperature selector 2 how
strongly the room should be warmed up.
7.4 Swivel function
The appliance has a swivel function.
This causes the appliance to swivel to and
fro, distributing the exiting air more evenly
through the room:
1. To switch the swivel function on, press
the swivel function button 3.
2. To switch the swivel function off, press
the swivel function button 3 again.
52

7. Operating

7.5 Thermal cut-out
For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance
becomes too high, the appliance switches
off automatically:
1. Turn the function selector 1 to
2. Check whether the air inlet or outlet is
obstructed and remove the cause.
If you cannot establish a cause and the
fault occurs repeatedly, have the
appliance repaired or else take it out of
use.
3. Wait for the appliance to cool down.
4. You can then continue to operate it
normally.
7.6 Safety switch
The appliance
accidental damage by a safety switch 11.
The safety switch 11 is located on the
bottom of the appliance and switches the
appliance off immediately should it fall over:
• Return the appliance to an upright
position. The appliance will switch on
again automatically.
7.7 Frost protection setting
With this function, the appliance prevents
the room temperature falling below the frost
line:
1. Turn the temperature selector 2 to
the frost symbol.
.
is protected against