Radio Reception - Teac AG-L800 Manuel Du Propriétaire

1
2
3
28

Radio Reception

1 Press the BAND button.
Each time you press the BAND button, the unit alternates
between AM and FM bands.
Alternatively, you can use the FM/AM button on the TUNER
BASIC (or ADVANCED) page of the remote control unit.
2 Select the AUTO mode by pressing the TUNING button.
"AUTO" should start blinking in the display.
< Each press of the TUNING button changes the mode as
follows:
PRESET AUTO
(function mode)
< When you select the function mode, only the frequency is
displayed, and the MULTI JOG knob is available for selecting
other sources.
3
Turn the MULTI JOG knob a little bit in either direction.
Turning the knob to the right lets the unit search for receivable
stations on upper frequencies. Turning the knob to the left lets
the unit search stations on lower frequencies.
Alternatively, you can use the g/t buttons on a TUNER page
(BASIC or ADVANCED) of the remote control unit.
When a station is tuned in, the tuning process will stop
automatically.
Press the TUNING button to stop the auto selection.
< Selecting stations which cannot be tuned to automatically.
(manual selection)
Press the TUNING button to get "MANUAL" displayed, blinking,
and then turn the MULTI JOG knob to the right or left. The
frequency will change in the following steps:
FM : 50kHz
AM : 9kHz
< "STEREO" is displayed when a stereo broadcast is tuned in.
< "TUNED" is displayed when a broadcast is correctly tuned in.
When a stereo FM broadcast is not clear, press the STEREO
button on a TUNER page of the remote control unit to switch into
the mono mode. The stridency will be less perceptible.
ENGLISH
MANUAL