The hours flash on the display.
• Select the current hours using the M1/
M2 memory buttons and confirm with the
START/STOP button
The minutes flash on the display.
• Choose the current minutes using the M1/
M2 memory buttons and confirm with the
START/STOP button
The Bluetooth
symbol flashes on the display.
®
• Use the M1/M2 memory buttons to choose whether
automatic Bluetooth
tooth
symbol flashes) or deactivated (Bluetooth
®
symbol is not shown) and confirm with the START/
STOP button
.
Bluetooth
transfers will reduce the battery capacity.
®
5. Measuring blood pressure
Please ensure the unit is at room temperature before measu-
ring.
The measurement can be performed on the left or right arm.
Attaching the cuff
Place the cuff on to the bare left upper
arm. The circulation of the arm must
not be hindered by tight clothing or
similar.
.
.
data transfer is activated (Blue-
®
The cuff must be placed on the upper
arm so that the bottom edge is
positioned 2 – 3 cm above the elbow
and over the artery. The line points to
the centre of the palm.
Now tighten the free end of the cuff,
but make sure that it is not too tight
around the arm and close the hook-
and-loop fastener. The cuff should be
fastened so that two fingers fit under
the cuff.
®
Now insert the cuff line into the
connection for the cuff connector.
If the measurement is performed
on the right upper arm, the line
should be located on the inside of
your elbow. Ensure that your arm is
not pressing on the line.
Blood pressure may vary between the right and left arm, which
may mean that the measured blood pressure values are diffe-
rent. Always perform the measurement on the same arm.
If the values between the two arms are significantly different,
please consult your doctor to determine which arm should be
used for the measurement.
Important: The unit may only be operated with the original cuff.
The cuff is suitable for an arm circumference of 22 to 36 cm.
25