Using The Extra Blades; Cleaning; Environment Concerns; Declaration Of Conformity - Klarstein 10027397 Mode D'emploi

• Use the Slicing blade for cheese, carrots, potatoes, cabbage, cucumber, courgette, beetroot and
onions. Use the Julienne blade for fi rm ingredients for salads, garnishes, casseroles and stir fries.
Use the Shred blade for cheese, carrots, potatoes and foods of a similar texture.
1 Take off the lid of chopper unit and chopping blade
2 Insert Slicing blade or Julienne blade or Shred blade into Blade holder
3 Set the Blade holder on the middle bar of the container.
4 Cover the lid into container. Screw tightly and lock it.
5 Fix the Body unit into the chopper unit. Lock it.
6 Take off Feeder presser from Feeder tube, Put ingredients in.
7 Connect to power. Push down the switch key and always use the Feeder presser to press down the
ingredients into container.
8 Not allowed to continuously use more than 30 seconds, should cool down at least 2 minutes. The
motion could not be more than 5 cycles.
9 After use, pull off the plug and disassemble the fi ttings.
WARNING
Before cleaning, please switch off power and pull out the plug and do not touch the sharp
chopping blade.
• Some ingredients, such as sugar cane, can leave pigments on the plastic surface of the container.
You can use a rag dipped with rap oil to wipe them out.
Body unit, Chopper lid, Whish connector
• Wiping with wet rag fi rst and then with dry rag.
• Don't dip them into water or clean them with caustic cleaning agent.
Blender, Chopper blade, Chopper container, Measuring cup, Extra Blades of Chopper
• Put half glass of water into the Measuring cup, put a little cleaning agent and dip then into the
water, then start the Body unit.
• Repeat the washing without cleaning agent for 2 times
• Pull off the plug and wipe it dry.
According to the European waste regulation 2002/96/EG this symbol on the product
or on its packaging indicates that this product may not be treated as household was-
te. Instead it should be taken to the appropriate collection point for the recycling of
electrical and electronic equipment. by ensuring this product is disposed of correctly,
you will help prevent potential negative consequences for the environment and hu-
man health, which could otherwiese be caused by inappropriate waste handling of
this product. For more detailled information about recycling of this product, please
contact your local council or your household waste disposial service.
Producer: CHAL-TEC GmbH, Wallstraße 16, 10179 Berlin.
This produkt is conform to the followring European Directives:
2014/35/EU (Low voltage)
2014/30/EU (EMC)
2011/65/EU (RoHS)
9

Using the Extra Blades

Cleaning

Environment Concerns

Declaration of Conformity