Mi-T-M GEN-1100-0MS0 Guide D'utilisation page 29

OPERATION
CABLE SIZE:
When a long electric extension cord is used to connect an appliance or
tool to the generator, a certain amount of voltage drop or loss occurs in
the extension cord which reduces the effective voltage available for the
appliance or tool. The chart below has been prepared to illustrate the
approximate voltage loss when an extension cord of 300 feet (approx.
00 meters) is used to connect an appliance or tool to the generator.
Equipment damage can result from low voltage. Therefore, to prevent
excessive voltage drop between the generator and the equipment,
the cable should be of adequate gauge for the length used. The cable
selection chart gives the maximum cable lengths for various gauges of
wire which can adequately carry the loads shown.
CURRENT LOAD IN WATTS
IN AMPS 20 VOLTS
2.5 300
5 600
7.5 900
0 200
5 800
20 2400
25 3000
30 3600
40 4800
Operator's Manual
Operating the Generator
240 VOLTS #8 WIRE
600
200
800
2400
3600
4800 75
6000 50
7200 25
9600 90
MAXIMUM CABLE LENGTH (FEET)
#0 WIRE #2 WIRE
000 600
500 300
350 200
250 50
50 00
25 75
00 60
65
#4 WIRE #6 WIRE
375 250
200 25
25 00
00 50
65
50
29