Focal TRIO6 BE Manuel D'utilisation page 15

TRIO6 BE
U s e r m a n u a l
Quick set-up guide:
1. First of all, check that the monitors and all audio sources (mixing console...) are turned off and that all settings
at the rear panel of the monitor are set to 0.
2. Connect the audio signal from the source to the monitors using the XLR input.
3. Check that the correct voltage is selected according to the mains power voltage chosen using the voltage
selector, check the fuse and replace if necessary. The amperage of the fuse depends on the operating voltage
(see fuse characteristics in specifications table). The monitor speakers absolutely must be grounded using
the power cable provided. See page 21 for more information.
4. Turn on the audio source and check that the output level of the audio source connected to the monitor is set
to -∞ or to a very low level.
5. Turn on the power to your monitors. The monitors are now in "Standby" mode.
6. Turn up the output level of the audio source until a signal is detected by the monitors in order for them to
turn on automatically.
After turning on the power to the monitors, and once the automatic Standby mode has been activated
(see page 21 for more information on this mode), the audio signal detection circuit within the monitor
will automatically switch from "Standby" to "On" after a few seconds.
7. Once you have finished recording, mixing or mastering, we recommend turning off your equipment in the
following order:
a. Turn off the monitors
b. Turn off the audio sources
TRIO6 Be
TRIO6 Be is a professional near-field monitor with 2 monitor speakers within the same cabinet. TRIO6 Be is
composed of an 8-inch subwoofer with a "W" composite sandwich cone, a 5-inch woofer with "W" composite
sandwich cone and a 1-inch pure Beryllium inverted dome tweeter.
In 3-way mode, the monitor has a frequency response of 35Hz to 40kHz (+/- 3dB) and 40Hz to 20kHz (+/-
1dB). In 2-way mode, only the 5-inch woofer and the tweeter are activated. The 2-way monitor speaker has a
frequency response of 90Hz to 20kHz (+/- 3 dB) and is very efficient for checking the transfer quality of mixes
carried out using systems with a limited bass range frequency response. These modes are controlled using a
footswitch (see page 21).
The TRIO6 Be monitor speaker is equipped with 3 internal amplifiers:
1 x 200W powering the 8-inch subwoofer
1 x 150W powering the 5-inch woofer
1x 100W powering the 1-inch tweeter
A
15