Fit The Collar - Petsafe PBC17-16635 Manuel D'utilisation

To Turn the Collar On
Press and hold the power button until you hear a low to high beep and
the green LED appears, and then release. The green LED will flash once
every 5 seconds.
To Turn the Collar Off
Press and hold the power button until the bark collar beeps high to
low, and then release. The red LED will be illuminated during the button
press and will turn off when the bark collar turns off.
Quick Tip: When not using the collar, turn it off to preserve
battery life.

Fit the Collar

Important: The proper fit and placement of the bark collar
is important for effective operation. The contact points must
have direct contact with your dog's skin on the underside of
his neck.
1. Make sure that the collar is turned off.
2. Start with your dog standing comfortably (2A).
3. Place the collar on your pet so that the PetSafe
and the collar is directly under your dog's chin. Centre the contact
points underneath your dog's neck, touching the skin (2B). NOTE: It
is sometimes necessary to trim the hair around the contact points
to make sure that contact is consistent. However, you should never
shave your pet's neck as this may increase risk of skin irritation.
4. Check the tightness of the collar by inserting one finger between the
end of a contact point and your dog's neck (2C). The fit should be
snug but not constricting.
5. Allow your dog to wear the collar for several minutes, and then
recheck the fit. Check the fit again as your dog becomes more
comfortable with the collar.
Do not shave the pet's neck as this may increase the risk of skin
irritation. The collar should not be worn for more than 12 hours out of
every 24-hour period. Leaving the collar on too long could lead to
skin irritation.
logo is right side up
®
petsafe.com
Charging Port
Power/LED
2A
2B
2C
5