Preparation Before Use - Hendi 975251 Mode D'emploi

3. PREPARATION BEFORE USE

1. Take the machine out of the wooden box by remov-
ing the upper and one of the side walls.
EN
6
2. Remove consumables from the machine's
chamber. Pour oil into the oil dispenser (if the
pump is empty or oil level is too low)
3.
HENDI 975251 and 975268
Remove back panel, remove the screw under the
panel and drain the used oil (afterwards insert the
screw back in position), remove the screw of oil fi ll-
er, pour the oil from oil container (afterwards insert
the screw back in position).
HENDI 975275
Remove the oil drain screw and drain the used
oil (afterwards insert the screw back in position),
remove the screw of oil fi ller, pour the oil from oil
container (afterwards insert the screw back in po-
sition).