Service Mode - Tunturi T50 Manuel De L'utilisateur

English
Body Fat
The Body Fat program is program to indicate your fiscal
state, based on your body parameters and heart rate.
- Press MODE/ ENTER button to open programming
mode.
- Press "SPEED/ INCLINE" buttons to select
BF program, press "MODE/ ENTER" button to
confirm.
- Press "SPEED/ INCLINE" buttons to set gender,
press "MODE/ ENTER" button to confirm.
- Press "SPEED/ INCLINE" buttons to set height,
press "MODE/ ENTER" button to confirm.
- Press "SPEED/ INCLINE" buttons to set weight,
press "MODE/ ENTER" button to confirm.
- Press "SPEED/ INCLINE" buttons to set age, press
"MODE/ ENTER" button to confirm.
- Gender, height, weight and age values are shown
in display and are fixed, no press "dial button" to
start measuring process, and hold hand-grip pulse
sensor plates.
CAUTION
• Holding the contact hand-grip heart rate
measurement pads is required for this function.
- Display Dot matrix screen will fill line by line from
bottom up, to show the progress.
- Test result will be shown in display.
- Press "RESET" button to leave Body Fat program.
Result calculation:
For example we use:
Body length :
Body weight :
Age :
- BMI = Body Mass Index:
Body weight ( kg) / body length ( M²)
Example : 80/ (1,80x1,80) = 24,69
- BMR = Basal Metabolic Rate
• Men: 13.7 x weight (kg) + 5.0 x height (cm) – 6.8
x age (years) + 66
• Women: 9.6 x weight (kg) + 1.8 x height (cm) –
4.7 x age (years) +655
- BODY TYPE: ( Body Fat ratio; 9 types)
• 1 : under 9%
• 2 : 10~14%
• 3 : 15~19%
• 4 : 20~24%
• 5 : 25~29%
• 6 : 30~34%
• 7 : 35~39%
• 8 : 40~44%
• 9 : 45~50%
- BF = Body Fat ( in ratio % )
Error code "ER" will show if no heart rate was detected
during the BF measurement process.
1,80 mtr
80 kg
40 years
(underweight)
(standard)
(overweight)

Service mode:

Some treadmill functions can be set to the customers
requirements.
Enter the service mode
Press SPEED UP button while holding the MODE/
ENTER button pressed.
NOTE
• When not able to get into the service mode,
remove safety key, and put back in place again
to reboot console software and try again.
When being in Service mode you can use the SPEED/
INCLINE buttons to adjust adjustable settings, and
press MODE/ ENTER button to confirm setting and
move to next stage in service mode.
# Menu Description
name
1 EN Shows console software
version.
2 Y Year of software release
3 D Day/ month of software
release.
4 T Time, shows time of
software release
5 T Shows Tunturi model
( T50 )
6 R Front roller diamter in
mm. ( ±10 300~800 )
DONT CHANGE !
7 Units Si = Metric system
showing Kilometers and
Kilograms.
En = Imperial system
showing Miles and Lbs.
8 Distance Shows total console
distance.
9 Time Shows total console
workout time in hours.
10 Pt Pause time in seconds.
( Adjust in 90-180-300 )
before console resets.
3 0
Default
600
Si
90