Care And Cleaning; Troubleshooting - Atag VA4611AT Mode D'emploi

26

CARE AND CLEANING

Warning! Before maintenance,
deactivate the appliance and
disconnect the mains plug from the
mains socket.
Cleaning the filters
B
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged,
remove remaining parts of soil with a thin
pointed object.
External cleaning
Clean the appliance with a moist soft cloth.

TROUBLESHOOTING

The appliance does not start or it stops
during operation.
1. Turn the filter (A) counterclockwise and
C
A
2. To disassemble the filter (A), pull apart
3. Remove the filter (B).
A1
4. Wash the filters with water.
5. Put the filter (B) to its initial position.
A2
6. Assemble the filter (A) and put it into
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.
Before you contact the Service, refer to the
information that follows for a solution to the
problem.
Dirty filters and clogged spray arms de-
crease the washing results.
Make a check regularly and, if neces-
sary, clean them.
remove it.
(A1) and (A2).
Make sure that it assembles correctly
under the two guides (C).
position in filter (B). Turn it clockwise
until it locks.
An incorrect position of the filters can
cause bad washing results and dam-
age to the appliance.