Acoustic Signals - Atag VA61211KT Notice D'utilisation

8
your area. It is important to set the right
level of the water softener to assure good
washing results.
Water hardness
German de-
grees (°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1) Factory setting.
2) Do not use salt at this level.
How to set the water softener
level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
the programme button until the
indicator
indicator comes on with fixed light.
2. Wait until the indicator
the indicator
indicator
intermittent flashing of the indicator
refers to the current set level.
• E.g. 5 flashes + pause + 5 flashes =
level5.
3. Press programme button repeatedly to
change the setting. Each time you press
programme button the level number
increases. After level 10 you will start
again from level 1.
French de-
grees (°fH)
84 - 90
76 - 83
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
<7
starts to flash and the
goes off and
starts to flash. The
continues to flash. The
mmol/l Clarke de-
grees
8.4 - 9.0 58 - 63
7.6 - 8.3 53 - 57
6.5 - 7.5 46 - 52
5.1 - 6.4 36 - 45
4.0 - 5.0 28 - 35
3.3 - 3.9 23 - 27
2.6 - 3.2 18 - 22
1.9 - 2.5 13 - 17
0.7 - 1.8 5 - 12
<0.7 < 5
4. Press the on/off button to confirm the
setting.

Acoustic signals

Acoustic signals sound when a malfunction
of the appliance occurs. It is not possible to
deactivate these acoustic signals.
There is also an acoustic signal that sounds
when the programme is completed. By
default this acoustic signal is deactivated
but it is possible to activate it.
How to activate the acoustic
signal for the end of programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
the programme button until the
Water softener
level
10
9
8
7
6
1)
5
4
3
2
2)
1