Paslode IM200Li.2 Manuel D'utilisation page 7

Safety Instructions
12. NEVER DRIVE FASTENERS INTO AREAS WITH
CONCEALED HAZARDS.
Always check the area behind the work surface for
electrical wiring, gas pipes, water pipes, sewer drains or
other potential hazards.
13. ALWAYS MAINTAIN SECURE AND UNOBSTRUCTED
FOOTING WHEN ON LADDERS, PLATFORMS OR
OTHER HIGH LOCATIONS.
14. ALLOW ONLY QUALIFIED PERSONNEL TO
OPERATE THE CORDLESS BRAD NAILER.
Battery Disposal:
The Paslode lithium-ion batteries contain lithium and must be recycled or disposed of properly. It is illegal in
some areas to place a lithium-ion battery into the trash or solid waste stream. You may contact your
local recycling information on where to return the spent battery.
6
WARNING
Never over-reach, since
tool recoil may cause a
loss of balance. Always
be aware of edges and
drop-offs when nailing on
rooftops and other high
locations. Keep them in
full view.
WARNING
Only persons who have read
and fully understand all tool
operation safety and
maintenance instructions
should be allowed to operate
the tool.
15. PROPERLY STORE FUEL CELL.
16. ALWAYS STORE THE TOOL WITH THE FUEL CELL
AND BATTERY REMOVED.
Store the fuel cell in the case with the Impulse Brad
Nailer.
17. KEEP THE TOOL CLEAN.
A clean tool is less likely to jam or malfunction.
18. KEEP YOUR HANDS CLEAR OF THE WORK AREA
SURFACE.
WARNING
Always store fuel cells
where they will not be
exposed to an open
flame, sparks or
temperatures above 4
(120 ).
WARNING
A fastener may exit at an
angle unexpectedly and
cause injury.