Electrical Safety - Palm Tungsten W Manuel D'utilisation

Informations relatives à la réglementation et à la sécurité
Exposure to radio frequency energy (SAR)
In order to comply with FCC radio frequency (RF) exposure guidelines, users must use a Palm™
brand body-worn accessory during body-worn operation. Use of accessories that are not provided
by Palm or that were not tested for RF exposure compliance with this product may not comply with
the FCC RF exposure safety guidelines and should not be used.
Maximum Specific Absorption Rate (SAR) value
This device has a maximum 0.41 W/kg per 10 grams based on EN50360 and EN50361 standards.

Electrical safety

This apparatus is intended for use when supplied with power from Motorola, p/n 163-1149 or
Phihong, p/n PSA05R-050. Other usage will invalidate any approval given to this apparatus and may
be dangerous.
Aircraft safety
Switch off your cellular telephone when in an aircraft. The use of cellular telephones in an aircraft
may be dangerous to the operation of the aircraft, disrupt the cellular network and is illegal. Failure
to observe this instruction may lead to suspension or denial of cellular telephone services to the
offender, or legal action or both.
Explosive Atmosphere
Users are advised not to use the equipment when at a refueling station.
Users are reminded of the need to observe restrictions on the use of radio equipment in fuel
depots, chemical plants or where blasting operations are in progress.
Road Safety
It is advised that a hand-held microphone or telephone handset should not be used by the driver
while the vehicle is moving, except in an emergency. Speak only into a fixed, neck slug or clipped-on
microphone when it would not distract your attention from the road.
Non-Ionizing radiation
As with other mobile radio transmitting equipment, users are advised that for satisfactory operation
of the equipment and for the safety of personnel, it is recommended that no part of the human body
be allowed to come too close to the antenna during the operation of the equipment.
Agency Compliance Information
Product regulatory and compliance information can be found in the Handbook file located on the
product CD-ROM.
WARNING
Division 2
WARNING
Modules
WARNING
The Area Is Known To Be Non-Hazardous
480
Explosion Hazard – Substitution Of Components May Impair Suitability For Class I,
Explosion Hazard – When In Hazardous Location, Turn Off Power Before Replacing Or Wiring
Explosion Hazard – Do Not Disconnect Equipment Unless Power Has Been Switched Off Or