SFA SANICOMPACT COMFORT+ Mode D'emploi page 22

EN
1 2 3
E
E
• Trace and cut the wall casing to create the evacuation passage.
• Glue two strips on each side of the frame as shown above.
E
• Glue the two remaining strips on each side to the inside of the wall casing as shown above.
4 5
•Insert the casing up to the wall, apply pressure to the hanging strips so that they stick together.
• Remove the protective film and complete the installation with a silicone seal around the casing if
necessary.
• Finalize the complete installation.
You can go directly to paragraph 9.
22