Detnov CCD-103 Mode D'emploi page 68

6.1.19- State 2 Sounder Output ( Fault, Activation) (19)
• The Left yellow LED indicates there is a fault in the output.
• The right red LED indicates the output is active.
6.1.20- State 1 Sounder Output ( Fault, Activation) (20)
• The Left yellow LED indicates there is a fault in the output.
• The right red LED indicates the output is active.
6.1.21- Triggering button input ( Fault, Activation) (21)
• The Left yellow LED indicates there is a fault in the input.
• The right red LED indicates the input is active.
GB
6.1.22- Stop button input ( Fault, Activation) (22)
• The Left yellow LED indicates there is a fault in the input.
• The right red LED indicates the input is active.
6.1.23- Pause button input ( Fault, Activation) (23)
• The Left yellow LED indicates there is a fault in the input.
• The right red LED indicates the input is active.
6.1.24- Door Surveillance input ( Fault, Activation) (24)
• The Left yellow LED indicates there is a fault in the input.
• The right red LED indicates the input is active.
6.1.25- Bottle 1 Surveillance input ( Pressure fault) (25)
• Blinking: There is a fault in the input.
6.1.26- Bottle 2 Surveillance input ( Flow fault) (26)
• Blinking: There is a fault in the input.
6.1.27- Pre activated state (27)
• Fixed: The system is in pre activated state.
6.1.28- Activated state(28)
Fixed: The system is in activated state.
•
6.1.29- Triggered state(29)
Blinking: The system is performing the bottle activation.
•
• Fixed: The system has finished the activation of the bottle output.
24