Checking Gas Pressure - Angelo Po 1G1FA0G Manuel D'utilisation

CLEANING OVEN
To carry out this operation, proceed as follows.
1 - Remove the bottom plate (C) and the grid (D)
from the oven and clean them thoroughly.
2 - Clean the inside parts of the oven to remove
any deposits which may impair its operation.
3 - Dry the surfaces and reassemble the compo-
nents.

CHECKING GAS PRESSURE

To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panel (B).
4 - Undo the screw (D) of the pressure connection.
5 - Connect the pressure gauge (E) to the pressure
test point (F).
6 - Turn the gas supply tap back on.
B
A
D
C
7 - Light one of the burners, turn the knob to the full
flame setting (see page 9) then check that the
pressure reading is the same as the val-
ues provided in the table (see back of
manual).
8 - Switch off the burner, turn off the gas sup-
ply tap and disconnect the pressure
gauge.
9 - Restore the initial conditions after com-
pleting the operation.
E
C
- 13 -
IDM-39618300600.tif
D
F
IDM-39618300700.tif
English
IT
GB
DE
FR
ES