Elvox Vimar PIXEL UP Manuel De L'utilisateur page 12

PIXEL UP: 40405 - 40425
2. Using the display module
In standby mode the device gives the instructions to follow to access the available features depending on the type of installation.
Currently three options are available for the style
of the home page displayed in stand-by and the
consequent methods of accessing the available
functions. The required page can be set in the
"Navigation" section of the display configuration
menu.
Depending on the programming of the contacts
list, the main screen of the display module will
show the following items: switchboard, contacts
list, entry actuator code and ID to call.
The figures opposite show a completely config-
ured outdoor station with all the items listed above.
2.1. Calling from the contacts list to an extension
Go to the contacts list
menu:
If pre-filters exist, scroll
through the sequence
and select the item in
the contacts list to call.
Press OK to cancel the
current call.
2.2 Searching for a name in the contacts list
You can search for a specific name in the contacts list also by using the multi tap function of the keypad.
From the list of names in the contacts list, press the letters forming the name
on the keypad. Each button must be pressed repeatedly until the desired
letter appears on the display.
The name being formed appears at the top of the display.
In this way the display is refreshed, indicating the first name that satisfies the
search. Then select the desired name and press OK.
Clearing the name being formed, with button C, restores the initial view.
The multitap function is always active in the screens where a list of users
appears.
12
SEARCH BY
NAME
CALL BY No
OPEN WITH
CODE
PORTER
Extended
Porter
SEARCH BY
NAME
Contacts
CALL BY No
OPEN WITH
CODE
PORTER
Select
with switchboard
Users
Cancel
Porter
Contacts
Internal
Select
Navigable
Contacts
Press
EN
Porter
Contacts
Internal
Direct
SEARCH BY
NAME
CALL BY No
OPEN WITH
CODE
PORTER
without switchboard