To Start The Product - Husqvarna 525P4S Manuel D'utilisation

• Never cut through the swelling at the root of the
branch as this will slow down healing and increase
the risk of fungal attack.
• Use the stop at the base of the cutting head to
provide support during cutting. This will help prevent
the cutting attachment from bouncing on the branch.
• Make an initial cut on the underside of the branch
before cutting through the branch. This will prevent
tearing of the bark, which could lead to slow healing
and cause permanent damage to the tree. The cut
should not be deeper than ⅓ of the branch thickness
to prevent jamming. Keep the chain running while
you withdraw the cutting attachment from the branch
to prevent it jamming.
14
To prepare the product for start
1. Press the air purge repeatedly until the fuel starts to
fill the bulb.
Note: It is not necessary to fully fill the bulb.
2. Move the choke control up into choke position.
WARNING: The saw chain will start to
rotate immediately when you start the
engine with the choke.

To start the product

WARNING: Read the warning instructions in
the safety chapter before you start the
product (refer to
1. Use protective gloves.
2. Hold the body of the product on the ground with your
left hand.
CAUTION: Do not use your feet!
3. Hold the starter rope handle.
4. Slowly pull out the starter rope with your right hand
until you feel some resistance (the starter pawl grip).
WARNING: Do not twist the starter rope
around your hand.
5. Pull the cord quickly and with power.
Safety on page 4 ).
703 - 005 - 20.10.2020