Switching Off; Temperature Regulation; Childlock Function - Electrolux IG0946S Notice D'utilisation

52 www.electrolux.com
It is possible to change predefined sound
of buttons by pressing together Mode
3.2 Display
A
3.3 Switching on
Connect the mains plug to the power
socket.
Press the appliance ON/OFF button if
the display is off.
The alarm buzzer could operate after few
seconds.
The temperature indicators show the set
default temperature.
To reset the alarm refer to "High
temperature alarm".
To select a different set temperature
refer to "Temperature regulation".
If DEMO appears on the display, refer to
"Troubleshooting".
If the door remains open for
some minutes, the light will
turn off automatically. The
light is reset by closing and
opening the door itself.

3.4 Switching off

Press the appliance ON/OFF for 5
seconds.
The display switches off.
To disconnect the appliance from the
power, disconnect the mains plug from
the power socket.

3.5 Temperature regulation

The set temperature of the freezer may
be adjusted by pressing the temperature
button.
Default temperature:
• -18°C for the freezer
The temperature indicator shows the set
temperature.
B C
F E D
and temperature colder button for a few
seconds. Change is reversible.
A. Timer indicator
B. FastFreeze function
C. Temperature indicator
D. Alarm indicator
E. ChildLock function
F. DrinksChill function
The set temperature will be
reached within 24 hours.
After a power failure the set
temperature remains stored.
3.6 FastFreeze function
The FastFreeze function accelerates the
freezing of fresh food and, at the same
time, protects foodstuffs already stored
from undesirable warming.
1. To activate this function press the
Mode button until the corresponding
icon appears.
The FastFreeze indicator flashes.
2. Press the OK button to confirm.
TheFastFreeze indicator is shown.
This function stops automatically after 52
hours.
To switch off the function before its
automatic end repeat the procedure until
the FastFreeze indicator turns off.
The function switches off by
selecting a different set
temperature.

3.7 ChildLock function

Activate the ChildLock function to lock
the buttons from unintentional operation.
1. Press Mode button until the
corresponding icon appears.
The ChildLock indicator flashes.
2. Press OK to confirm.
The ChildLock indicator is shown.
To deactivate the ChildLock function,
repeat the procedure until the ChildLock
indicator goes off.