Full Loaded position
5
3.2 Switching on
Leave the appliance to stand upright for 4
hours after installation.
Insert the plug into the wall socket.
1. The Green Indicator Light will light up
and remain lit until the appliance is
switched off.
2. Leave to run for 8 hours to allow the
correct temperature to be reached
before placing food inside.
The Red Indicator Light will stay on
until the correct temperature is
reached.
3. When the appliance has reached the
set temperature (the Red Indicator
Light has gone out) adjust the
Temperature Regulator according to
the quantity of the stored foods.
A few hours after starting up
the Red Indicator Light will go
out to show that the correct
temperature has been
reached for the setting
chosen and will stay out to
indicate that everything is in
order. It will come on if the
freezer temperature rises
unduly for instance, after
opening the freezer door or
placing food inside the
cabinet, but the light should
go out again when the
temperature returns to the
correct storage level.
4. FIRST USE
4.1 Cleaning the interior
Before using the appliance for the first
time, the interior and all internal
accessories should be washed with
lukewarm water and some neutral soap to
remove the typical smell of a brand-new
product, then dried thoroughly.
3.3 Switching off
1. To turn off the appliance, disconnect
the mains plug from the wall socket.
2. To disconnect the appliance from the
power, disconnect the mains plug
from the wall socket.
3.4 Temperature regulation
The temperature within the appliance is
controlled by the Temperature Regulator
situated on the control panel.
To operate the appliance, proceed as
follows:
• turn the Temperature Regulator toward
MIN to obtain the minimum coldness.
• turn the Temperature Regulator toward
MAX to obtain the maximum coldness.
In case of freezing less food
volumes, the Half Loaded
setting is the most suitable. In
case of freezing large food
volumes, the Full Loaded
setting is the most suitable.
CAUTION!
Do not place heavy nor hot
objects on top of the
appliance to avoid any
damage.
CAUTION!
Do not use detergents or
abrasive powders, as these
will damage the finish.
ENGLISH
21