Switching Off; Temperature Regulation; High Temperature Alarm - Electrolux EUN1100FOW Notice D'utilisation

6 www.electrolux.com
3.2 Switching on
Connect the appliance to the main power
supply.
1. Turn the Temperature regulator
clockwise to a medium setting.
The pilot light will light up and a sound will
signal for 2 seconds.
If the temperature inside the
appliance is too high, the
Alarm light will blink and the
sound signal alarm will turn
on.
2. Push the FastFreeze switch and the
sound signal alarm will get off.
3. Push the FastFreeze switch once
again and the FastFreeze light will light
up. The appliance will start to operate.

3.3 Switching off

Turn the Temperature regulator to the "O"
position and a sound is on only for 2
seconds .
The pilot light will switch off.

3.4 Temperature regulation

The temperature is regulated
automatically.
A medium setting is generally
the most suitable.
However, the exact setting
should be chosen keeping in
mind that the temperature
inside the appliance depends
on:
• room temperature,
• how often the door is
• the quantity of food
• the location of the
1. Turn the Temperature regulator
toward lower settings to obtain the
minimum coldness.
All manuals and user guides at all-guides.com
opened,
stored,
appliance.
2. Turn the Temperature regulator
toward higher settings to obtain the
maximum coldness.
CAUTION!
If the ambient temperature is
high or the appliance is fully
loaded, and the appliance is
set to the lowest
temperatures, it may run
continuously causing frost to
form on the rear wall. In this
case the dial must be set to a
higher temperature to allow
automatic defrosting and
therefore reduced energy
consumption.
3.5 FastFreeze function
You can activate FastFreeze function by
pressing the FastFreeze switch. The
FastFreeze light will light up.
It is possible to deactivate the function at
any time by pressing FastFreeze switch.
The FastFreeze light will switch off.

3.6 High temperature alarm

If the temperature inside the freezer has
risen to a point where the safe storage of
frozen food is no longer ensured (for
example due to an power failure), the
Alarm light will blink and an acoustic alarm
will sound.
When the freezer is first
switched on, the Alarm light
blinks until the temperature
has dropped to a safe level
for the storage of frozen food.
1. Switch off the warning tone by
pressing the FastFreeze switch.
The FastFreeze indicator appears.
The Alarm light blinks until the required
temperature has been reached again.
2. Release theFastFreeze switch as soon
as the Alarm light is off.
The FastFreeze indicator turns off.