Installing The Speakers On The Tallboy Stand - Samsung HT-J4500 Guide D'utilisation

Connections

Installing the Speakers on the Tallboy Stand

* HT-J4530 only - Front Speakers
1. Turn the Stand Base upside-down and
connect it to the Stand.
2. Use the driver to combine the screws on the
3 marked holes.
3. Straighten a supplied speaker wire to the
gravity direction and put in the hole on the
center of Stand Base.
4. Connect the upper Speaker to the assembled
Stand.
5. Insert a screw clockwise into the hole on the
rear of the speaker using a screwdriver.
And then connect a speaker cable.
6. This is the appearance after the speaker is
installed.
Follow this steps to install other speaker.
Speaker Cable Connections
1. Match each speaker cable bundle to the correct speaker by matching the colored band on each bundle to
the colored sticker on the bottom of each speaker.
2. Connect the speaker wire plugs from each speaker to the back of the product by matching the colored
band on each cable to the colors of the speaker jacks. When connecting, make sure to match label color
on the back of speaker.
In case of HT-J4500
Front Speaker (L)
Center Speaker
Refer to page 6 for the speakers of HT-J4530.
Subwoofer
SURROUND
SURROUND
10
1
Stand Base
Stand
3
5
Surround Speaker (L)
SURROUND
Surround Speaker (R)
SURROUND
Front Speaker (R)
- English
2
4
Speaker
Stand
6