Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Maintenance
The MCS is virtually a maintenance-free device. In dusty or granular applications,
periodically check the load cell stops for material build-up. Remove any build-up in the
mechanism to ensure that the load cell maintains free movement.
Note:
Re-install the shipping stops during maintenance or any other time when
protection of the load cells is required.
Spare Parts
The only spare part recommended for the MCS is the load cell. Refer to the load cell
nameplate for the proper size and model number.
Re-balance any load cell that has been replaced. Refer to the Load Cell Balancing
Procedure For Four Load Cells in the integrator manual.
Maintenance Precautions
•
When welding near the scale, do not allow current to pass through the belt scale.
•
Reset the shipping stops to reduce physical shock to the load cells during
maintenance.
•
Recalibrate the scale after maintenance and prior to use.
7ML19985HN63 Milltronics MCS Belt Scale – INSTRUCTION MANUAL
Page 21
Publicité
Table des Matières
