Wiring Diagram (Electronic) - Napoleon BL36 Instructions D'installation Et D'opération

Masquer les pouces Voir aussi pour BL36:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

42
6.7

WIRING DIAGRAM (ELECTRONIC)

EN
This appliance comes equipped with a battery back-up. If this back-up is used, install 4AA batteries (not
supplied) into the holder and connect to the wire harness.
TRANSFORMER
BATTERY
HOUSING
(SUPPLIED IN
MANUAL BAGGIE)
DC SUPPLY
NOTE: The battery holder was supplied with your appliance but not connected. In an event of a power
failure, install four 'AA' batteries in the holder and attach to wire harness as illustrated above.
W415-1442 / C / 06.06.16
!
DO NOT WIRE 110 VOLTS TO THE VALVE OR WALL SWITCH
ACS/IPI
SWITCH
(OPTIONAL)
ON / OFF
SWITCH
IPI / CPI
ON / OFF
DISCONNECT THESE
CONNECTIONS TO THE
ON/OFF SWITCH AND
CONNECT TO AN
OPTIONAL THERMOSTAT.
WARNING
VALVE
GROUND
EYELET
GROUND
GREEN
ORANGE
VALVE
ELECTRONIC
IPI BOARD
DFC
69.7

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Bl36nteBl36pte

Table des Matières