Wiring Diagram (Electronic) - Napoleon B35NT Instructions D'installation Et D'opération

44
6.8

WIRING DIAGRAM (ELECTRONIC)

EN
This appliance comes equipped with a battery back-up. If this back-up is used, install 4AA batteries (not
supplied) into the holder and connect to the wire harness.
TRANSFORMER
BATTERY
HOUSING
(SUPPLIED IN
MANUAL BAGGIE)
DC SUPPLY
NOTE: The battery holder was supplied with your appliance but not connected. In an event of a power
failure, install four 'AA' batteries in the holder and attach to wire harness as illustrated above.
W415-1399 / B / 06.17.16
!
DO NOT WIRE 110 VOLTS TO THE VALVE OR WALL SWITCH
ACS/IPI
SWITCH
(OPTIONAL)
ON / OFF
SWITCH
IPI / CPI
ON / OFF
DISCONNECT THESE
CONNECTIONS TO THE
ON/OFF SWITCH AND
CONNECT TO AN
OPTIONAL THERMOSTAT.
WARNING
VALVE
GROUND
EYELET
GROUND
GREEN
ORANGE
VALVE
ELECTRONIC
IPI BOARD
DFC
69.7