Factory Settings - TechniSat TECHNIRADIO 6 IR Notice D'utilisation

> Use the SELECT knob to select one of the available languages and confirm the
selection by pressing the SELECT knob.

14.6 Factory settings

If you change the location of the device, e.g. when moving house, it is possible that
the saved stations can no longer be received. In this case you can reset the device to
Factory Settings to delete all the saved stations and then launch a new scan.
> Open Menu > [System settings] > [Factory settings] and press the SELECT
knob.
> Use the SELECT knob to select the [Yes] item to reset the factory settings and
press the SELECT knob.
All previously stored stations and settings will now be deleted. The device is
now in the same status as when delivered.
> The display will show [Restart ...] and the device will start with the initial
set-up wizard. Please note the scan settings in Section „8 Ersteinrichtung" auf
Seite 111 when doing so.
150