TechniSat TECHNIRADIO 6 IR Notice D'utilisation page 112

If you have selected Update from the NET, you must then select the time
zone in the next step so that the time is displayed correctly. Proceed to specify
whether summertime or wintertime is applicable at the time of setting.
> In the next step you can specify whether the TECHNIRADIO 6 IR should remain
connected to the Internet when in standby. Power consumption is, however,
increased by using the standby mode.
> The network wizard then starts and you can set up an Internet connection.
Select the WLAN network you are familiar with by turning and then press the
SELECT knob. Then select [Skip WPS] and enter the relevant password for
your WLAN connection on the displayed keyboard. Then select
press the SELECT knob. If the password entered is correct, a connection to the
network is now established. The signal bar
indicates whether the connection has been established. To cancel the entry,
select
delete the last letter you entered using
112
and press the SELECT knob. If you make a typing error you can
in the status bar on the display
.
and