Air Filter Reminders (Optional); Maintenance - Pre-Season Inspection - HTW IX39B-R32 Manuel De L'utilisateur

CAUTION
• Before changing the filter or cleaning,
turn off the unit and disconnect its
power supply.
• When removing filter, do not touch metal
parts in the unit. The sharp metal edges
can cut you.
• Do not use water to clean the inside of
the indoor unit.
insulation and cause electrical shock.
• Do not expose filter to direct sunlight
when drying. This can shrink the filter.

Air Filter Reminders (Optional)

Air Filter Cleaning Reminder
After 240 hours of use, the display window on
the indoor unit will flash "CL." This is a
reminder to clean your filter. After 15
seconds, the unit will revert to its previous
display.
To reset the reminder, press the LED button
on your remote control 4 times, or press the
MANUAL CONTROL button 3 times. If you
don't reset the reminder, the "CL" indicator
will flash again when you restart the unit.
Air Filter Replacement Reminder
After 2,880 hours of use, the display window
on the indoor unit will flash "nF." This is a
reminder to replace your filter. After 15
seconds, the unit will revert to its previous
display.
To reset the reminder, press the LED button
on your remote control 4 times, or press the
MANUAL CONTROL button 3 times. If you
don't reset the reminder, the "nF" indicator will
flash again when you restart the unit.
CAUTION
• Any maintenance
outdoor unit should be performed by an
authorized dealer or licensed service
provider.
•
Any unit repairs should be performed
by authorized dealer or licensed
servic e provider.
Page 13


This can destroy
and cleaning of
Maintenance – Long Periods of
Non-UseIf you
If you plan not to use your air conditioner for
an extended period of time, do the following:
Clean all filters
Turn off the unit and
disconnect the power
Maintenance –
Pre-Season Inspection
After long periods of non-use, or before
periods of frequent use, do the following:
Check for damaged wires
Check for leaks
Make sure nothing is blocking all air inlets and outlets
Turn on FAN function
until unit dries out
completely
Remove batteries
from remote
control
Clean all filters
Replace batteries