3M PROTECTA 2190055 Manuel D'utilisation page 4

A
INSTALLATION:
Step 1:
Mark location for anchor. Observe minimum edge
distance and spacing requirements. See reverse
side of label for additional requirements.
Step 2:
Drill 11/16", 18mm, or 3/4" diameter hole to a depth
of 4 3/8 inches.
Step 3:
A Clean hole using blow-out bulb or compressed air.
Step 4:
Tap anchor into hole using a hammer. Anchor
flange must seat firmly against concrete.
Step 5:
Tighten bolt to 44 ft-lbs (60 N-m) with torque wrench.
Do not use impact tool.
Concrete minimum compressive strength 3000 psi. Not for use
in lightweight concrete, hollow block, brick, grout, or stone.
1
3M.com/FallProtection
3
B
MATERIALS: Zinc plated steel anchor bolt, stainless steel D-ring
bracket, zinc plated steel D-ring
4
CAPACITY: 1 person, 310 lbs max.
MFRD /LOT NO: MODEL NO:
(YR/MO)
5
10
B
11
1
7
INSPECTION LOG
This product meets DATE INITIAL
ANSI Z359.18 Type A
OSHA 1910.140. and
1926.502 requirements.
2
6
4
B
A
Hole size: 4 3/8 in. deep X
11/16 in., 18mm, or 3/4 in diameter
Min. Anchor Spacing (s) = 10 in.
2
Min. Edge Distance (c) = 15 in.
Min. Base Thickness (h) = 6 1/4 in.
3
INSPECTION:
Inspect anchor before each use.
Do not use if inspection reveals
unsafe or defective condition.
8
C
s
c
A
c
h
B