GYS DIAG-STARTIUM 60-12 Mode D'emploi page 13

Translation of the original instructions
• If your eyes or skin come into contact with battery acid, rinse the
affected part of the body with plenty of water and seek immediate
medical assistance.
Connection / disconnection:
• Disconnect the power supply before connecting/disconnecting
the device to/from the battery
• The terminal of the battery that is not connected to the car frame
must be connected first. The other connection must be made on
the car frame, far from the battery and the fuel line. The battery
charger must be connected to the power supply network.
• After the charging process, disconnect the battery charger from
the power supply network and remove the connector from the
car frame and then the connector from the battery, in this order.
Connection:
• This device must be connected to an earthed power supply
• This equipment is intended for industrial environments (class A)
Class A
and not for residential sites where the electric current is supplied
by the public low-voltage power supply network. There may be
potential difficulties in ensuring electromagnetic compatibility on
these sites, because of the conducted interferences, as well as
radiated radioelectrical frequency.
• This product does not comply with IEC 61000-3-12 and is in-
tended to be connected to private low voltage networks which
are connected to public supply network only at the medium and
high voltage level. If connected to a public low-voltage supply
network, it is the responsibility of the installer or user of the equip-
ment to ensure, by consulting the operator of the electrical distri-
bution network, that the hardware can be connected.
Maintenance:
• If the power supply cable is damaged, it must be replaced by the
manufacturer, its service agent or an equally qualified person.
• Service should be performed by a qualified person.
• Warning! Always remove the power plug from the wall socket
before carrying out any work on the device.
• Regularly take off the cover and remove dust with an air gun. Take
the opportunity to have a qualified person check the electrical
connections with an insulated tool.
• Under no circumstances should solvents or other aggressive
cleaning agents be used.
• Clean the device's surfaces with a soft, dry cloth.
Regulations
• The device complies with European Directive.
• The certificate of compliance is available on our website.
DIAG-STARTIUM 60-12 / 60-24 EN
13