Rittal VX CMC III DK 7030.232 Notice D'installation Et D'utilisation Succincte page 9

5.3 Settings
A MIFARE transponder card (13.56 MHz) is included with the transponder reader as standard.
◾ Hold the supplied transponder card in front of the transponder reader.
The card is then authorised to release the handle.
Access authorisations are configured on the Configuration index tab on the Web interface of
the CMC III PU or PU Compact. Alternatively, the access authorisation can also be edited in the
"access.cmc3" file. After the first access attempt, this file is contained in the upload folder on the
CMC III PU or PU Compact. It can be downloaded with FTP and then changed with an editor.
Further information concerning this topic is contained in the main guide at www.rittal.com (see sec-
tion 1.1).
◾ Hold an authorised transponder card in front of the transponder reader unit.
The "ACCESS" LED lights continually for approx. 2 seconds (fig. 2, pos. 3).
◾ Hold an unauthorised transponder card in front of the transponder reader unit.
The "ERROR" LED lights continually for approx. 2 seconds (fig. 2, pos. 1).
To determine whether any software updates are required: see www.rittal.com or contact
Rittal Service (see section 6).
6 Service
For technical questions, please contact:
Tel.: +49 (0) 2772/505-9052
E-mail: info@rittal.de
Homepage: www.rittal.com
For complaints or service requests, please contact:
Tel.: +49 (0) 2772/505-1855
E-mail: service@rittal.de
Rittal CMC III transponder reader VX
Installation and operation, Service
EN
9