Operation; Start Page; Monitor Display; Status Bar - Sicam SBMV955 Notice Originale

en 38 | SBMV955 | Operation
7.

Operation

7.1

Start page

i
The initialization of the software is displayed approx.
20 seconds after switching on the SBMV955. The
start page is displayed after a further 40 seconds.
Pressing <F1> opens the "main page".
The following functions can be selected on the main
page:
<F1> Call-up of "Manual rim data input" menu
<F2> Call-up of "Balancing programs" menu
<F3> Selection of number of spokes
<F4> Call-up of "Unbalance minimization" program
<F5> Call-up of "Settings and service" menu
<F6> User selection
7.2

Monitor display

Fig. 4: Main page

1 Status bar

2 Display fi eld

3 Softkey bar

7.2.1 Status bar
The following information is displayed depending on
the menu selected:
+
Current operator.
+
Current balancing program.
+
Type of vehicle selected.
| |
656 407 2010-11-22
+
Number of wheel spokes selected in "split program".
+
"Position braking" function activated/deactivated.
7.2.2 Display field
The following information is displayed here:
+
Wheel data and positioning of vernier caliper/gauge
arm.
+
Information on positioning and mass of the balance
weights.
7.2.3 Softkey bar
The softkey bar indicates the functions available in
the corresponding menu. The functions are started by
pressing the function keys <F1> to <F6>.
7.2.4

Function and control keys

The function and control keys (Fig. 1, Item 4) are used
to operate the SBMV955. The corresponding functions
are described in table 2.
Fig. 5: Function and control keys
Key Description
<F1> to <F6> Function keys, function depending on
the symbols in the softkey bar.
Arrow keys Navigation in menus and for altering wheel data.
<OK> Storage of settings selected.
<STOP> Termination of measurement,
display of exact value if key is held pressed.
<START> Start of measurement.
Tab. 1: Functions of function and control keys
7.2.5

EXIT key

Symbol Description
F1
Press < > to return to the "
This key is used for exit from the selected menu and
return to the "main page".
i
Values can only be stored by pressing the <OK> key.
main page
".
Sicam snc società unipersonale