Electrical Connection; Checking The Direction Of Rotation; Compressed Air Connection; Calibration Of Sbmv955 - Sicam SBMV955 Notice Originale

en 34 | SBMV955 | Commissioning
4.5

Electrical connection

!
The SBMV955 is only to be connected to the power
supply if the mains voltage available corresponds to
the rated voltage given on the rating plate.
1. Check whether the mains voltage corresponds to the
rated voltage given on the rating plate.
2. Provide fuse protection for the SBMV955 mains con-
nection in line with locally applicable standards. The
customer is responsible for providing fuse protection
for the mains connection.
3. Connect the power cord to the SBMV955.
2
3
Fig. 3: Electrical connection
1 On/off switch
2 Mains connection
3 Power cord
4.6

Checking the direction of rotation

1. Check that the SBMV955 is correctly connected to
the mains power supply.
2. Switch on the SBMV955 with the On/Off switch.
3. Close the wheel guard or press the <START> button).
« The shaft rotates.
4. Check the direction of rotation of the shaft.
i
The correct direction of rotation is indicated by a
yellow arrow on the SBMV955. This arrow is situated
to the right of the flange.
i
If the direction of rotation is incorrect, the SBMV955
comes to an immediate stop and displays the error
message (see section 10 ).
Error 3
| |
656 407 2010-11-22
1
4.7

Compressed air connection

1. Connect the SBMV955 to the compressed air supply.
2. Set a pressure of between 8 bar and 12 bar.
« First pull the pressure reducer (red knurled
screw) upwards and then turn to set the pressure
to between 8 and 12 bar.
« Check the pressure on the pressure gauge.
!
The pressure must never exceed 12 bar!
4.8

Calibration of SBMV955

!
Calibration must be performed after initial commis-
sioning.
1. Flange calibration.
2. Vernier caliper calibration.
3. SBMV955 calibration.
4. Perform reference measurement.
i
Calibration is described in Section 11.4
Sicam snc società unipersonale