Maximum Operating Time Exceeded; Oven Light - Thermador Professionl Série Mode D'emploi

Fan is running during modes that do not use
convection.
Warm air or steam escapes from oven vent.
Cooling fan runs even when the oven is turned off.
Oven door closes faster/slower than normal.
The appliance prompts you to descale without the
counter appearing beforehand.
The "Fill water tank" message appears even though
the water tank is full.
When cooking with steam, a lot of steam is produced. The appliance is being automatically calibrated and is a
The appliance cannot be switched on or is on and
cannot be operated; the
display.
The appliance does not heat up;
display.
There is a "pop" noise during cooking.

Maximum Operating Time Exceeded

Your appliance automatically ends the operation if no
duration has been set and the setting has not been
changed for 24 hours.
The actual cooking time until the operation is stopped
automatically varies according to the selected settings.
A message appears on the display on the appliance to
say that the operation is being ended automatically.
Afterwards, the operation is stopped.
To use the appliance again, first switch it off. To switch
the appliance back on set the required operation.

Oven Light

Steam Oven Cavity Bulbs
To light the interior of your steam oven cavity, your
appliance has one or more long-life LED bulbs.
However, if ever an LED bulb or the bulb's glass cover
fails, call Customer Service. The lamp cover cannot be
removed.
52
symbol is shown on the
‚
is shown on the
6
On some models, the convection fan runs while the oven is
preheating for the bake mode. This is normal.
It is normal to see or feel steam or warm air escaping from
the oven vent. Do not block the vent.
This is normal. The cooling fan will continue to run, even after
the oven has been turned off, until the oven has cooled
sufficiently.
The soft-close door hinges contain a damping fluid that is
affected by temperature. If the oven is in a cold environment,
the door will close slower than it will in a warmer environment.
A warmer than normal environment, such as when cooking,
may cause the door to close slightly faster.
The set water hardness range is too low. Check the set water
hardness range and adjust if necessary. Carry out descaling.
Check that the water tank is fully pushed in to place. The tank
could also possibly be damaged from being dropped. Due to
impact, components inside the water tank have come loose
and the tank is leaking. If the message still appears and
neither of these problems are the issue, it may need a new
sensor. Call Customer Service.
normal occurance.
The panel lock is activated. Press and hold the TIMERS touch
button until the symbol goes away.
‚
Demo mode is activated in the basic settings. Turn demo
mode to OFF in the settings menu.
Cold/warm effect with food, caused by the steam.
Conventional Oven Cavity Bulbs
To replace the halogen bulb on the oven sidewall:
Tools required
Narrow flat blade screw-
driver (blade tip width 1/
5" (5 mm) or less to fit in
slot).
Flashlight (to see socket
holes to plug in bulb
prongs).
G-9 Halogen bulb