Removing The Mask; Disassembling The Mask; Cleaning The Mask In The Home - ResMed Mirage Liberty Mode D'emploi

•
Have you cleaned your mask recently? Oils on the cushion and pillows can
affect the seal.
•
Are the pillows correctly seated in your nostrils? Re-seat or adjust the
pillows to obtain a proper seal.
•
Are your headgear straps overtightened? Try not to alter the upper headgear
straps once they have been tightened by your clinician.
•
If you cannot establish a comfortable seal, do not overtighten the headgear.
Consult your clinician.
•
Try another nasal pillow size.
If you cannot resolve any problems, look at the Troubleshooting section, or talk
to your clinician.

Removing the Mask

To remove the Mirage Liberty:
1 Detach the elbow by squeezing the elbow on both sides and pulling it away
from the frame (C-1).
2 Unclip both of the lower headgear clips (C-2) and remove the mask.
Note: You can detach the elbow from the mask frame and leave the mask on
your face. You may prefer to do this when briefly stopping therapy, for
example to go to the bathroom.

Disassembling the Mask

See section C on the illustrations sheet.
1 Unclip the upper headgear clips from the frame (C-3).
2 Carefully pull the mouth cushion away from the frame (C-4).
3 Push the two nasal pillows down through the mouth cushion (C-5).
4 Remove the ports cap (C-6).
5 Detach the inlet tube assembly from the elbow.
Note: The swivel does not need to be disconnected from the inlet tube.
6 Detach the valve clip from the elbow (C-7).
7 Peel the valve from the valve clip (C-8).
Note: Do not pull on the valve flap, as this may cause it to tear.

Cleaning the Mask in the Home

Notes:
•
The mask and headgear can only be cleaned by handwashing.
•
The headgear may be washed without removing the headgear clips.
4