Safety Warnings - Festool ETS 125 REQ Notice D'utilisation D'origine

English
Contents
1 Symbols..................................................... 12

2 Safety warnings.........................................12

3 Intended use..............................................13
4 Technical data........................................... 13
5 Parts of the machine.................................13
6 Operation................................................... 14
7 Settings......................................................14
8 Working with the electric power tool........15
9 Service and maintenance..........................16
10 Accessories............................................... 16
11 Environment.............................................. 16
12 General information.................................. 16
1 Symbols
Warning of general danger
Warning of electric shock
Read the operating manual and safety
instructions.
Wear ear protection.
Wear a dust mask.
Wear protective goggles.
Connecting the mains power cable
Disconnecting the mains power cable
Pull out the mains plug
Do not dispose of it with domestic
waste.
Safety class II
CE marking: Confirms the conformity
of the power tool with the European
Community directives.
Tool contains a chip which stores data.
See section 12.1
Tip or advice
Handling instruction
12
2 Safety warnings
2.1 General power tool safety warnings
WARNING! Read all safety warnings, in­
structions, illustrations and specifica­
tions provided with this power tool. Failure to
follow all instructions listed below may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
- Only for AS/NZS: The tool shall always be
supplied via residual current device with a
rated residual current of 30 mA or less.
2.2 Machine-specific safety notices
Harmful/poisonous dust may be produced
-
when working (e.g. paint products con­
taining lead and some types of wood).
Contact with or inhalation of this dust may
pose a risk for the operating personnel or
persons in the vicinity. Comply with the
safety regulations that apply in your coun­
try.
-
Wear suitable personal protective equip­
ment: Ear protection and safety goggles.
- Wear a P2 respiratory mask to protect
your health. In enclosed spaces, ensure
that there is sufficient ventilation and con­
nect a mobile dust extractor.
Clean using materials soaked in oils, e.g.
-
abrasive pad or polishing felt with water,
and spread them out to dry. Materials
soaked in oil may ignite spontaneously.
- Caution: Fire hazard! Prevent the material
being sanded and the sander from over­
heating. Always empty the dust container
before taking breaks from work. Grinding
dust in the filter bag and/or in the filter of
the mobile dust extractor may ignite spon­
taneously under unfavourable conditions,
such as flying sparks, when sanding. There
is a particular risk if the sanding dust is
mixed with clear coats or polyurethane res­
idues or other chemical substances and the
material being sanded becomes hot after it
has been worked on for a long time.
- Metals and materials that contain asbestos
must not be processed. Sparks may be cre­