AEG DD 9863 Mode D'emploi page 83

• Fix the lower duct in place using two screws, working from inside
the cooker hood, then close off the holes using the small plug caps
(13).
• Pull out the upper flue and, at the top, fix it to bracket G using 2
screws (14).
Fit the grease filters, the inner crosspiece and the perimeter air suction
panels.
Connect the hood to the mains electricity (wait about 15 seconds, the
time needed to calibrate the electronic device that controls the
functioning of the hood), and check, finally, that it is functioning well.
2 x Ø 2,9x6,5
2 x Ø 3,5x6,5
Fig. 9
G
83