AEG DD 9863 Mode D'emploi page 80

First decide which functioning
version is better for you
If you decide to use the hood in exhausting
version we suggest you position the upper
section of the chimney so that the oulet
slots are not visible once installation has
ended, on the contrary if it is decided to
use the hood in recycling version BE SURE
that the side with the slots is upright (see
also A-B-C sequence).
Assembling the chimney flue
support/bracket (3 parts)
The three parts should be fixed with 4
screws, the support extension is
adjustable and should correspond to the
internal width of the telescopic chimney
flue.
Assembling the deflector
(3 parts – only for filter
version):
The three parts should be fixed with 2
screws, the deflector extension is
adjustable and should correspond to the
width of the chimney flue support, to
which it is then fixed.
80
A
C - OK!
4 x Ø 4x8
=
=
X
X
=
F
Ø 3,5 x 6,5
F
B
180°
G
X
=
6 x
G