Electrical Connection; Before Beginning Installation - AEG DD 9863 Mode D'emploi

Electrical connection

Safety warnings for the electrician
The mains power supply must correspond to the rating indicated on
the plate situated inside the hood. If provided with a plug connect the
hood to a socket in compliance with current regulations and positioned
in an accessible area. If it not fitted with a plug (direct mains
connection) or if the plug is not located in an accessible area apply a
bi-polar switch in accordance with standards which assures the
complete disconnection of the mains under conditions relating to over-
current category III, in accordance with installation instructions.
IMPORTANT: Before re-connecting the hood circuit to the mains
supply and checking the efficient function, always check that the
mains cable is correctly assembled.

Before beginning installation

• In addition check whether near the installation area of the hood (in
the area accessible also with the hood mounted) an electric
connection to the mains is available and if it is possible to connect a
fumes discharge device to the outside (Extraction mode only).
• Warning! Do not connect the appliance to the mains until the
installation is fully complete.
79