Set-Up; Trap Placement; Burying The Cord - Mosquito Magnet PATRIOT PLUS Manuel De L'utilisateur

Trap Placement

1. Determine the direction of the prevailing wind.
Check local weather patterns if you are unsure.
2. Stand in the center of the area you are trying to protect
and look toward the prevailing wind.
3. Proper placement of the trap will be 9-12 m (30-40 ft.) in
front of you, within 1.5-1.8 m (5-6 ft.) of mosquito habitat
(i.e., standing water, bushes, flowerbeds, treeline, marshbed,
etc.). Ensure that trap is not directly against any blockades
such as buildings, fences, etc.
4. It is recommended that the trap be placed in the shade.
5. Do not place trap directly above a water source
(sprinklers, hose, etc.).
6. Trap must be placed on level ground to avoid tipping
or uneven propane distribution.
7. Go to www.mosquitomagnet.com to build your own yard
diagram.
Burying the Power Cord
Make sure unit is unplugged and in proper position. Use the
Cord Burying Clips supplied. Place clips approximately
1 m (3 feet) apart, press into ground by hand making sure not
to damage power cord. For alternate placement, follow steps
illustrated below.
1. Use straightedge shovel or garden spade and dig a trench
about 8-10 cm (3"-4") deep from power source to trap.
2. Place cord into trench carefully stretching as you go to
remove any twists in cord.
3. Use cedar shingle or folded cardboard to place cord into
bottom of trench. Recover the trench with removed soil.
7

Set-Up