Disassembly; Disconnecting The Connecting Plugs; Driver Disassembly; Disassembling Driver With Assembly Adapter On Hat-Rail - Brüel & Kjaer Vibro ds822 Serie Mode D'emploi

4 mm displacement sensor system series ds822 ATEX
EN
Instructions

7 Disassembly

Observe the safety information in chapter Safety!
Follow reverse order for disassembly:
7.1

Disconnecting the connecting plugs

see "Connection via extension cable" on page 55
7.2

Driver disassembly

7.2.1 Disassembling driver with assembly adapter on hat-rail

1. Use a screwdriver to pull the tab forward and vertically lift off the adapter containing the
driver.
2. To remove the assembly adapter, push the adapter's tappet (opposite of mounting tab)
downward and slide off the driver.

7.2.2 Disassembling driver with assembly adapter, screw-mounted

1. Remove screws
2. Remove assembly adapter
7.3

Replacing displacement sensor system components

1. Switch off voltage.
2. Replace the individual components with equivalent components.
3. Check that all parts of the displacement sensor system have been reconnected correctly.
4. Switch on voltage.
l
27 © Brüel & Kjaer Vibro GmbH / 4 mm ds822 ATEX / 9.11.16 / technical specifications subject to change / C105070001/ V03
| Disassembly