Connecting And Disconnecting Plug Connections; Connection Via Extension Cable; Direct Connection - Brüel & Kjaer Vibro ds822 Serie Mode D'emploi

4 mm displacement sensor system series ds822 ATEX
EN
Instructions

4.3.1 Connecting and disconnecting plug connections

The connector ends of the displacement sensor and the extension cable feature self-latching
plug connections. They are plugged together, and not joined by a screw connection.
To assemble, observe the following order:
1. Hold one of both plug connector
2. Push both plug connectors together until they audibly click into place.
To disconnect, observe the following order:
1. Hold one of both plug connector
2. Pull on the silver serrated part of the plug

4.3.2 Connection via extension cable

1. Connect the extension cable with the integrated cable of the displacement sensor.
2. Connect the extension cable to the driver.

4.3.3 Direct connection

Connect the displacement sensor directly to the driver.

l
17 © Brüel & Kjaer Vibro GmbH / 4 mm ds822 ATEX / 9.11.16 / technical specifications subject to change / C105070001/ V03
ends in each hand.
ends in each hand.
to disconnect the connection.
| Installation