Ibiza Light QUAD6-FX Manuel D'utilisation page 5

DMX ADDRESS SETTING
1. Press the MENU, UP or DOWN button until "ADDR" is displayed, press ENTER.
2. The current address will now be displayed and flashing. Press the UP or DOWN buttons to find your desired
address. Press ENTER to confirm.
DMX CHANNEL MODE
1. Press the MENU button until "CHND" is displayed, press ENTER. Either "11CH", "15CH" will be displayed
2. Press the UP or DOWN buttons to find your desired DMX channel mode and press ENTER to confirm and exit.
SLND – SLAVE MODE
To select Slnd, press the ENTER button to show the SLAVE MODE on the display. Use the DOWN/UP button to
select Mast (MASTER),Sl1 (SLAVE 1), Sl2 (SLAVE 2) modes. Once the mode has been selected, press the ENTER
button to confirm.
NOTE: In a Master/Slave configuration you can set one fixture to Master and then set the next fixture to "SL 2", the fixtures will now have
opposite movements to each other.
SHOW MODES 0-15 (FACTORY PROGRAMS).
Show mode can run with or without sound active mode active.
1. Press the MENU button until "SHND" is displayed, press ENTER.
2. "Sh X" will now be displayed, "X" representing a number between 0-15. Programs 1-15 are factory programs,
while "Sh 0" is random mode. Press the UP or DOWN buttons to find your desired show.
3. When you have found your desired show press ENTER, then press and hold the MENU button for at least
3 seconds to activate. After you have set your desired show, it can be changed at any time using the UP or
DOWN buttons.
AUTO PROGRAM
1. Press the MENU button until "AUTO" is displayed, press ENTER.
2. The Display will show either "ON" or "OFF". Press the UP or DOWN buttons to select "ON" or "OFF".
SOUND ACTIVE MODE
1. Press the MENU button until "SOUN" is displayed, press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or DOWN buttons to select "ON" to activate the
sound active mode, or "OFF" to deactivate the sound active mode.
3. Press ENTER, then press and hold the MENU button for at least 3 seconds to activate.
SOUND SENSITIVITY
1. Press the MENU button until "SENS" is displayed, press ENTER.
2. A number between 0-100 will be displayed. Press the UP or DOWN buttons to adjust the sound sensitivity. 0
being the least sensitive and 100 being the most sensitive.
3. When you have found your desired setting, press ENTER to confirm.
PAN INVERSION
1. Press the MENU button until "PINT" is displayed, press ENTER. Either "YES" or "NO" will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons until YES is displayed, press ENTER to confirm.
3. To deactivate Pan inversion, select NO and press Enter.
TILT1 INVERSION
1. Press the MENU button until "TINI" is displayed, press ENTER. Either "YES" or "NO" will be displayed.
2. To activate the Tilt1 inversion press the UP or DOWN buttons until YES is displayed, press ENTER to confirm.
3. To deactivate Tilt1 inversion, select NO and press Enter.
TILT2 INVERSION
1. Press the MENU button until "TIN2" is displayed, press ENTER. Either "YES" or "NO" will be displayed.
2. To activate the Tilt2 inversion press the UP or DOWN buttons until YES is displayed, press ENTER to confirm.
3. To deactivate Tilt2 inversion, select NO and press Enter.
Manual - QUAD6-LED
SETTINGS
www.ibiza-light.com
EN
5