Install The Hood; Install Blower - Broan Elite E662E Mode D'emploi

6. INSTALL THE HOOD

6.1 Run power cable to installation location. Position the hood in its intended location. Using a pen, mark the position
of the screws smaller part of the keyholes, see pictures below for the (5) keyhole locations). Remove the hood.
6.2 Install (4) #8 x ½" screws, leaving a
HD0138
6.3 Insert the power cable in the hood and tighten the wire clamp to secure the cable. Place the hood under the
cabinet and slide it in position. Tighten the (4) screws completely, then add the last screw (screw #5) in the center
keyhole.
6.4 Turn the rough-in plate upside down and use the (4) screws
(previously removed in step 5.3) to install it inside the hood.

7. INSTALL BLOWER

EXTERIOR BLOWER:
1 / '' gap (do not install the #5 screw yet).
8
HD0136
Refer to instructions packed with exterior blower.
HD0135
- 4 -
HD0137