Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PREPARE THE HOOD
NON - DUCTED CONFIGURATION, cont'd.
8. Carefully place the lower decorative flue
into the recessed area of the range hood
top. Fig. 7
9. Carefully slide the upper decorative flue
down inside the lower flue.
Note: air vents must be up. Fig. 7
10.Secure the recirculation plenum to the
upper flue with (4) flat head screws.
Fig. 9
INSTALL THE
HOOD
Note: at least two people
will be required to mount
the hood.
1. Raise the hood into its
mounting position.
2. Plug the power cord into
the
electric
receptacle. Tuck excess
cord behind the flue.
3. Align the rectangular opening on the back
of the hood with the wall-mounting
bracket. Gently lower the hood until it
securely engages the bracket. Fig. 10
4. Level the hood with 2 screws (3.9x9.5mm)
and secure with (4) mounting screws.
Use drywall anchors provided if wall studs
or framing are not available. Fig. 10
5. Raise the upper flue until its holes align
with holes in the flue mounting bracket
(located on ceiling). Fig. 11
6. Secure the flue with (2) mounting screws.
Fig. 11
SCREWS
(3.9x9.5mm)
MOUNTING
SCREWS
(4.8x38mm)
wall
- 10 -
MOUNTING
SCREWS
(4.8x38mm)
3.9x9.5mm
MOUNTING SCREWS
PLENUM
4 FLAT
HEAD
SCREWS
UPPER
FLUE
FIG. 9
WALL FRAMING
MOUNTING
BRACKET
RECTANGULAR
CUTOUT
FIG.10
FIG.11
Publicité
Table des Matières
