Install The Hood - Broan Elite RMP1 Serie Mode D'emploi

INSTALL THE DUCTWORK
Ducted configuration
NOTE: To reduce the risk of fire, use only
metal ductwork.
1. Decide where the ductwork will run between
the hood and the outside.
2. A straight, short duct run will allow the hood
to perform most efficiently.
3. Long duct runs, elbows, and transitions will
reduce the performance of the hood. Use
as few of them as possible. Larger ducting
may be required for best performance with
longer duct runs.
4. Install a roof or wall cap. Connect round
metal ductwork to cap and work back to-
wards hood location. Use duct tape to seal
the joints between ductwork sections.

INSTALL THE HOOD

1. Remove the grease filters by pushing filter
towards the back of hood and rotating filter
downward.
2. Remove the metal grille by turning the (2)
knobs counterclockwise.
3. Cut a hole in the bottom of the cabinet, using
the dimensions shown.
4. Adjust the position of the clasping side spring
by means of the proper screw, according to
the thickness of the panel to which it is going
to be anchored.
5. Insert the hood in the cabinet and lock it by
means of the side spring.
6. Use the holes in the casing of the hood to
attach it using 4 mounting screws
(3.2x13mm).
7. Replace grille and filters.
CUT A HOLE IN THE BOTTOM OF
THE CABINET
26-11/16"
10-1/4"
- 5 -
ROOF CAP
HOOD
24" TO 30" ABOVE
COOKING SURFACE
METAL GRILLE
GREASE FILTERS
MOUNTING SCREWS
(3.2x13mm)
CLASPING
SIDE SPRING
min 7-16"
max 13/16"
ROUND
DUCT
WALL
CAP
6"
ROUND
ELBOW
KNOB