Cabinet Preparation; Cutting Holes; Prepare The Hood - Broan Elite E662E Mode D'emploi

3. CABINET PREPARATION

The cabinet must support the total weight of the hood. For the E662E hood model, the total weight
is 20 lb (9 kg).
If the cabinet needs to be reinforced, add wood blocks to strengthen the
connection between the bottom of the cabinet and its sides, as shown
beside.

4. CUTTING HOLES

See figure beside for cut-out dimensions in the bottom of the cabinet.

5. PREPARE THE HOOD

5.1 Pull latch tabs and remove filters from the hood.
5.2 Remove (3) screws holding both side panels to the hood and set aside.
5.3 Remove (4) screws retaining the rough-in plate from the top of the hood
and set aside.
5.4 Punch out 2 knock-out holes for electrical connections (2 on top or one on top and one on back of the hood). Install
the wire clamps.
WARNING
!
HH0041A
- 3 -
A
DD WOOD BLOCKS
HD0139
CABINET BOTTOM
C L
10" dia.
1½"
5 7/8"
7/8'' 1¼''
HD0133
2
1
HO0042
HD0134
2"
4½"
3